Turbo Heat Shield GEN 3 Onyx - Single T25 / T28

The best Turbo heat protection blanket on the market

New Onyx GEN 3 DEI - the strongest, most heat resistant shield available for T25 / T28 turbine housing and similar

DEI raised the bar! The most technologically advanced turbo shield ever!

DEI incorporated all their experience to build the absolute best Onyx turbo shield on the market. By developing advanced textiles and diving deep into what is needed to control turbo heat, DEI developed the GEN-3 Onyx Turbo Shield. A Silicone coated Onyx outer layer with multiple stainless steel and silica inner layers. Without a doubt the strongest, most heat resistant shield available.

OUTER SHELL

• Coated in silicone to insulate and hold up under extreme conditions
• Prevents fraying & encases seams to make them over 4 times stronger

INSULATION LAYER

• Thick layer of silica insulation keep heat in turbo shield and turbo housing
• Silica has a low thermal conductivity making one of the best insulators

INNER LAYER

• Stainless steel, glass fiber & silicone adds to insulating and thermal properties
• Increases seam strength, durability and insulation value

INNER COVER

• Stainless Steel fabric holds up against the highest temps
• Will not break down or become brittle with heat

Direct Heat Resistance: 1800°F

Radiant Heat Resistance: 1400°C / 2500°F

Size: T25/28

Color: Onyx

Kit: with shield and wire only

TURBO APPLICATION GUIDE Measuring your turbo size

• DEI Turbo shield sizes are based on two basic measurements. The first measurement is the circumference of the turbo not including the flange. The second measurement is the width of the turbo at it’s widest point not including the flanges. After measuring, refer to the chart below to find the correct shield.

Our T22 and T25/28 shields are designed for use on internally gated housings. They will have a cutout in the wastegate area to allow for a tight fitment..

Price per kit as depicted, without turbine housing.

For instance fits to the following T25 / T28 turbine housings:

- Garrett GT2554R, GT2560R, GT2854R, GT2860R, GT2860RS, GT2871R, GT2876R, GT3071R-WG, GT3076R-WG

- (recommended for turbos w/ internal wastegates)

- Outer circumference: 19”

- Inner width: approximately 2-1/2”

Heat resistant up to 1400° C

Only buy original titanium heat protection products!

With us you get the original titanium heat protection products from the USA. If you observe the market a little, you will notice that there are many similar products, which are offered as titanium heat protection and look exactly like that. This often much cheaper material comes from China, is much harder and therefore more brittle. It is not comparable to ours. The heat rejection and life are much worse. Do not save money at the wrong end. Take the original!